-40%

Universal Aluminum EZ-Install Hood Louvers GT 3 (11"W x 19.5"L each)

$ 56.97

Availability: 25 in stock
  • Returns Accepted: ReturnsNotAccepted
  • Surface Finish: Unfinished
  • Manufacturer Part Number: VRSW14
  • Mounting Hardware Included: No
  • Fitment Type: Performance/Custom
  • Type: Hood/Fender Vent
  • Brand: VRaptor SpeedWorks, LLC
  • Material: Aluminum
  • Condition: New

    Description

    Drastically lower under-hood temps, reduce under-hood pressure/lift, reduce wheel well pressure, increase downforce with these custom EZ-Install hood/fender louvers from VRaptor SpeedWorks, LLC.  This auction is for our GT 3 Louvers.  Made from aluminum, these louvered panels come with louver braces.  Each one of the pair of louvered panels is 11" wide and 19.5" long overall.  Please note that these louvers are bare aluminum (not painted or powdercoated) and ship flat and do require some assembly.  While the louvers are flat, use them as your cut template to mark the cut opening in your hood/fender.  This design allows you to use the louvers to mark out the cut on your hood using the inner part of the perimeter, cut the hole slightly oversized from your marks and the perimeter of the louvers will hide the cut edge of the hood.....so you can install these on a painted hood without having to repaint the hood when done.  These louvers also come with a mounting brace that holds each louver blade to the proper angle and reinforces the panel, providing additional rigidity.  These can be installed with screws or rivets (not included).
    The first Gallery photo shows what you are buying in this auction.  Other photos are close-up example photos of what similar louvers look like and how they are constructed as well as tips for installation.
    1.  Use the flat louvered panel as you template to trace the inner part of the perimeter. (see photo)
    2.  Make your cut line slightly larger than the inner perimeter. (see photo)
    3.  Cut your holes. (see photo)
    4.  Use the slots in the braces as a guide to form your louvers to the correct angle. (see photo)
    5.  Install your louvers.  I would recommend using 1/8" aluminum rivets for a clean look.
    VRaptor SpeedWorks, LLC is the original designer/manufacturer of louvers of this type.  All other similar louvers that you see advertised are copies of our designs and made from thinner, cheaper material.  We have many different sizes and shapes available to fit nearly any application.  The sample panel of 3 louvered panels in the photos above is just one example of how versatile our louvers are.....choose the sizes and shapes that best fit your needs.  The smaller louvers on each side of that panel are our 4"x12" Angled Hood/Fender Louvers.  The center louver is our 5.5"x12" Rectangle Hood/Fender Louvers.